|
DESCRIPTION: A breathing, satin, water-repellent,
oil based finish for use on interior timber, cork, unglazed floor
tiles and porous stone surfaces. Bio Teak Oil can be used as a
complete finish. Do not use on alkaline surfaces, plaster,
concrete, fibro cement or in a constantly humid environment. Test
strips should be made on other materials such as brick and ceramic
tiles.
PREPARATION: Do not apply coatings to unseasoned or
wet timber. Wood should be well sanded, dry and cleaned of greasy,
waxy and dirty contaminants using BIO Thinner. Round off sharp
edges. It is also good practice to prime back surfaces. Hardwoods
and timbers rich in natural oils, waxes, acids and terpenes should
be degreased using Bio Thinner to ensure these substances do not
mix with the varnish and prolong its drying time. Let dry for 24
hours. Imperfect coats may require complete stripping before
applying BIO products. Final sanding before application should be
done with sandpaper grade 120 or 180
APPLICATION: Brush, dip or spray. Do not apply more
than the surface can absorb. Maintain a wet edge when
painting. Remove excess oil with a dry lint free cloth after
10-20 Minutes. Apply one to two thin coat, or up to four thin coats
on highly absorbent surfaces. Allow first coat to dry for 24-48
hours. Sand lightly with fine-grain sandpaper, then repeat the
process with each coat. When using on floor boards start to
polish the oil immediately after you have removed the excess oil.
Do not use when the temperature is below 10+ C and/or the relative
humidity is above 80% e.g. cold damp conditions, or when
condensation, frost are likely to occur or hot days and
direct sunlight and hot surfaces. Provide adequate ventilation
during application and drying.
DRYING: Touch dry after 5-7 hours. Do not walk on
treated floors for 3 days. Normal use after 7-10 days.
FINISHING TREATMENT: For greater protection, a thin
coat of BIO ANTIQUE WAX or BIO HARD FLOOR WAX may be applied after
drying. For regular maintenance of floor boards use BIO TIMBER CARE
POLISH.
INGREDIENTS: Based on plant oils, resins, essential
oils, paraffin oil, lead free drying agent.
COVERAGE: 1 Litre covers approx. 8 - 12 sqm.,
depending on the absorbency of the substrate.
On floors only: Softwood approx. 20-30 sqm & Hardwood
approx. 25-40 sqm.
PACAKAGING: 1 and 4 Litres
STORAGE: Keep tightly sealed in a cool, dry place. Decant
remains into a smaller container to minimise reaction with air, as
skin may form once container has been opened.
DISPOSAL: Do not pour left over oil down the drain.
Unwanted oil should be brushed out on newspaper, allowed to dry and
then disposed of via domestic waste collection. Let empty container
dry out well and dispose via recycling program.
PRECAUTION: Keep away from open flames and out of
the reach of children. Please dispose of used rags in a sealed
metal container. Can spontaneously combust
The preceding information was prepared by BIO Products Australia
and is given as a general guide only. Some variations may occur or
be advisable for particular conditions. The manufacturer’s
responsibility for claims arising from breach of warranty,
negligence or otherwise is limited to the purchase price of the
material.
BIO TEAK OIL is an environmentally friendly product.
1/08/2007
view pdf version
(93k)
| 