|
DESCRIPTION: BIO Wood Varnish is a varnish and
stain in one product. Earth minerals, natural oils and resins are
the basic ingredients which makes it a beautiful coloured finish.
The natural and non toxic ingredients are gentle to the climate and
resources. It is a hard, elastic, semi-transparent varnish for use
on timber surfaces exposed to sun and rain. It is resistant to dirt
and moisture..
PROTECTION: Protection against weather,
wood-destroying ultra-violet light is determined by pigment
density. In areas of greater exposure 3 coats are recommended to
build up pigment density or 1 coat of Bio Wood Primer plus 2 coats
of Bio Wood Varnish. Minimum dry film thickness on an even smooth
surface: 60 micron, better 100 micron. Box frames, timber windows,
cladding and end grains must be treated with BIO Wood Primer and
one coat of BIO Wood Varnish BEFORE INSTALLATION. It is also good
practice to prime all back surfaces. Re-apply once the finish
appears to become dull.
PREPARATION:
Prepare surface in accordance with AS 2311 Painting of
Buildings. Do not apply coatings to unseasoned or wet timber. Wood
and other surfaces should be well sanded, dry and cleaned of
greasy, waxy and dirty contaminants using BIO Thinner. Round off
sharp edges. Imperfect coats may require complete stripping
before applying BIO products. Hardwoods and other timbers rich in
natural oils, waxes, acids and terpenes should be degreased using
BIO Thinner, because these substances may mix with the varnish and
prolong its drying time. Do not apply over acrylic, PUR or epoxy
based coatings.
APPLICATION: Stir thoroughly before use with a
broad flat stirrer. Brush thinly and evenly working varnish well
into the grain. Maintain a wet edge when painting. Thick coats
wrinkle when dry. Avoid bubbles. Lightly sand between coats if
necessary with fine sandpaper. Allow 12 to 24 hours to dry between
coats. Low temperatures and humid conditions prolong the drying
time. Apply second and subsequent coats only after previous coat
has thoroughly dried. Do not use below 10°C and or above 80%
humidity, in cold damp conditions, when condensation, rain,
dew or frost are likely to occur or hot days, direct sunlight or
hot surfaces. Provide adequate ventilation during application
and drying. Reaches maximum durability after 8-14 days.
VARIATION OF USES: White/ Limed floor - 1st coat is a diluted BIO WOOD
VARNISH GLOSS COLOURED white blended with up to 50% BIO THINNER
depending on whiteness that you want.
Finished with 2 coats of BIO FLOOR
VARNISH.
RE-COATING: Exterior: Re-coating is recommended
after approximately 2 or 3 years, depending on the exposure to the
weather.
COLOURS: All colours are intermixable. Slight
variations between lots are possible. Special colours are available
on request. Standard colours are: Redwood, Pine, Mahogany, Green,
Grey, Teak, Ebony, Black, Red, Walnut, Oak & White. Colours by
Nature can also mix you custom colours from the standard colours if
desired.
CLEANING: Clean with BIO Thinner.
COVERAGE: 1 L covers approx. 10-12 sqm.
PACKAGING: 1 L and 4 L.
INGREDIENTS: Based on modified plant oil, wood oil,
rosin, titanium dioxide, mica, silica, bentone, soya lecithin,
UV-protector, paraffin oil, lemon peel oil, Lead free drying
agents.
STORAGE: Keep tightly sealed in a cool and dry
place. Surface film may develop in opened cans.
PAINT DISPOSAL: Do not pour left over paint down
the drain. Unwanted paint should be brushed out on newspaper,
allowed to dry and then disposed of via domestic waste collection.
Let empty container dry out as well and dispose via recycling
program.
PRECAUTION: Keep away from open flames and out of
reach of children. Do not misuse. Please dispose of used rags in a
sealed metal container. Can spontaneously combust.There is no
manufacturer’s liability for applying this product onto non
compatible paint systems like acrylics, polyurethane, epoxy
finishes etc.
The preceding information was prepared by BIO Products Australia
and is given as a general guide only. Some variations may occur or
be advisable for particular conditions. The manufacturer’s
responsibility for claims arising from breach of warranty,
negligence or otherwise is limited to the purchase price of the
material.
BIO WOOD VARNISHES are environmental friendly products.
1/08/2007
BIO Wood Primer
BUY NOW from Online
Store
View pdf
version | 