|
DESCRIPTION: Solvent free, non-drip, long-lasting
interior wall and ceiling paint. Clay Decor can be applied to most
interior surfaces such as Gyprock, timber, masonry, brick and fibre
cement without priming. Clay Décor can be used exterior in frost
free regions and water protected areas. VOLVOX Clay Decor is
permeable to vapour and absorbs variations in humidity providing a
more comfortable and healthy living environment. Due to its high
proportion of solids VOLVOX Clay Decor covers exceptionally well
(99.55%).
Colours & Sizes:
- Mont Blanc (White) 1, 5 & 10litre
- Ivory (Off White) 1& 5litre
- Dacar (Ochre) 1 & 4litre
- Sienna (Orange) 1 & 4litre
- Terracotta (Red) 1 & 4litre
- Polar (Green) 1& 4litre
- Smoke (Grey) 1 & 4litre
View VOLVOX Colour
Selections
ENVIRONMENT AND HEALTH FEATURES: Clay Decor is made
from natural and non-toxic raw materials. Manufacturing process
ensures ecological sustainability and avoids water pollution. The
product will not charge electro static energy. When used according
to manufacturer’s direction, the product is harmless to human and
the environment. Certified EU Eco-Label Licence No.: UK 7/1
SURFACE PREPARATION Remove dirt, grease, oil and loose,
peeling and flaking material. Fill cracks and holes with a filler.
Sand the surface smooth after and remove all dust. Sandy and
powdery surfaces should be primed with suitable primer such as
VOLVOX Lasur Binder. Stains, water marks, nicotine etc. must be
treated with suitable oil based priming paint. Light sanding is
recommended when painting over glossy or semi-gloss surfaces. Prime
all metallic surfaces using a metal primer first. Mould and fungus
must be permanently removed before applying VOLVOX Clay Decor.
APPLICATION: Generally apply two coats of VOLVOX
Clay Decor by roller, brush or spry. Spread the Decor evenly in all
directions. On light-coloured even surfaces one coat is sufficient.
On very absorbent surfaces such as Gyprock, plaster, sandstone etc.
application may be eased by dampening the surface with water and/or
reducing the first coat with up to 5% water. Allow each coat to dry
completely before re-painting.
Do not apply in
temperatures below 10°C or above 25°C. For a good finish
ensure any dry paint around lid is not allowed to drop into the
paint when opening, if necessary strain paint. It is very important to stir paint
well prior to each application using a mechanical stirring
device, for example, a commercial stirrer attached to
powerful slow speed power drill. Do not use paint equipment, in
particular rollers and brushes that have been previously used with
conventional synthetic paints.
DRYING AND RECOATING: VOVOX Clay Decor will
normally dry within 2–6 hours and may be recoated after. In cold or
humid conditions drying time may be lengthened. VOLVOX Clay Decor
will be completely dry and cured after 10 days.
COVERAGE: 1 litre will cover up to 8 sq. metres
depending on texture and porosity of surface.
CLEAN UP: With water away from drains.
INGREDIENTS: Water, clay coming from various pits,
chalk, kaolin, vinegar ester, methylcellulose, titanium dioxide
(White Clay Décor only), 0,1% synthetic preservatives
SAFETY: Even if non-toxic, Clay Decors should be
kept out of reach of children.
STORAGE AND SHELF LIFE: Store tightly sealed in a
cool and dry place. Minimum shelf life for unopened and properly
stored cans is 24 months. Protect against frost.
DISPOSAL: Allow unwanted Clay Decor to dry. Solid
matter should be disposed of via the normal garbage collection
service.
The preceding technical information sheet was prepared by Amma
Earth Australia and is intended to provide guidelines for users.
Volvox products are guaranteed to give satisfactory performance
only if used as recommended. Liability shall be limited to refund
of purchase price or the replacement of a defective product. There
are no other warranties expressed or implied.
Disclaimer: The user is recommended to test the
product on the intended surface to ensure its suitability.
Made in Germany.
September 2006
BUY NOW from Online
Store
view pdf version (28k) | 