|
Range of application: Teak, Bankirai, Larch, Douglas
pine, Cedar. For exterior use only. For first treatment and
maintenance.
Technical qualities: Produces a water repellent, open-pored
finish. Fast drying, refreshes. No chipping or flaking. Surface
finish is even and easy to maintain.
Full declaration: Linseed oil, wood oil, linseed oil - wood
oil - stand oil, orange oil, Isoaliphates, linseed oil - stand oil
- natural resin ester, earth - and mineral pigments and drying
agents free of lead.
Colours: 048 chestnut*, 072 oak, 554 oregon pine, 022
boxwood, 068 light teak, 101 black, 593 larch.
*Corresponds with the colour tone of many exotic hardwoods.
Depending on the type of wood and the surface roughness, the colour
impression can vary considerably. The rougher the wood, the darker
the colour.
Application method: By brush or roller. (See reverse for
further information)
VARIATION OF USES:
Coverage: Exotic hardwoods, robinia, oak: First coat, 1
liter (1.06 fl. quart.) is sufficient for approximately 28 m2 (301
ft2). Second coat, 1 liter is sufficient for approximately 40 m2
(431 ft2). Soft wood: First coat, 1 liter (1.06 fl. quart.) is
sufficient for approximately 20 m2 (215 ft2). Second coat, 1 liter
is sufficient for approximately 28 m2 (301 ft2). On profiled wood
the consumption can be up to 3 times higher. A test coat is
recommended!
Drying time: At 23oC (73o F) and a relative humidity of 50%
appr. 5 - 8 hours at good light- and ventilation conditions. Second
coat after 18 hours drying time.
Specific gravity: Appr. 0.87 g/ml.
Safety advice: Contains limonene, May cause sensitisation by
skin contact, Keep out of the reach of children. If swallowed, do
not induce vomiting: seek medical advice immediately and show this
container or label. Irritant.
Disposal: According to locally regulated laws.
Container sizes: 0.25 lt; 0.75 lt; 2.5 lt.
Storage: Cool and dry, please see label for expiry date.
Preparation: The surface must be able to absorb, solid,
clean, dry and free of dust
Application Apply 2 coats by brush in the direction of the
wood grain at temperatures above 10°C (50°F). After 5 — 10 minutes
spread out any unabsorbed product. Apply sparingly, surface must
not be sticky. Alternatively with roller, spreading out unabsorbed
product with brush. Before using, always test product on an
inconspicuous spot to check compatibility with the existing surface
and previously applied polishes or maintaining products. Refresh
with ALIS Decking Oil at least once a year or as required.
Important tips: Treat strongly weathered exterior areas,
such as porch floorings or wooden fences only after complete drying
of the wood. As Bangkirai and Teak lose their moisture very slowly,
treat these timbers in the dry season only. Protect the dry decking
against dew by covering with a tarpaulin the evening before. Odour
forming possible, until drying is complete.
BUY NOW from Online
Store
View pdf
version |
