|
Range of
application: Plaster,
concrete, masonry, oatmeal wallpaper, gypsum board, as well as
sound water-based painted surfaces. Not suitable for textile and
vinyl wallpaper.
Technical qualities:
Free of solvents,
produces a bright white, wipe-able, antistatic finish. High water
vapor permeability. Easy to apply, with no tendency to blotch or
splatter. DIN 55 987 certified for coverage strength.
Full
declaration: Water,
chalk, talcum, titan dioxide, kaolin, beeswax soap, methyl
cellulose, safflower stand-oiland silver chloride.
Color: White.
Application
method: Stir product
thoroughly before using. Apply one undiluted coat with a brush, or
lambs-wool roller at room temperatures above 10°C (50°F).
Do a test coat for adhesion and compatibility.
Coverage: 1 undiluted liter (1.06 fl. quart.) is
sufficient for approximately 9 m2(97
ft2) per coat, i.e. 111 ml/m2. Coverage could be considerably less depending
upon the condition and absorbency of the surface. Always do a test
application.
Drying time: At 23°C
(73°F) and 50% relative humidity, dry to the
touch after approximately 12 hours. Fully hardened and ready for
subsequent coating with plant-based paints after 3 - 5
days.
Cleaning up: Clean equipment immediately after use
with water, eventually with LATIS Tool Cleaner No. 558.
Specific
gravity: Approximately
1.3 g/ml.
Safety advice: Keep out of the reach of
children.
Disposal: According to locally regulated
laws.
Container
sizes: 1l; 5l; 10 l;
30l.
Storage: Cool and dry, protected from frost and
freezing. Use contents of opened containers within 2-3 days.
Please, see label for expiration date.
Packaging: Made of polyethylene (PE). This material is
ground water neutral and recyclable.
General surface Requirements
and Preparation: The
surface must by dry, solid, able to absorb and bear load, neutral,
clean, and free of separation agents, cracks, efflorescences and
fungi. Fill holes and cracks with VEDO Filler No. 440. Structural
cracks must be repaired with a crack-bridging repair system. DUBRON
Wall & Ceiling Paint No. 406 can be diluted with max. 10 %
water for priming.
Important
tips: For
maximum results, do not mix with products of other manufacturers
for coloring, varnishing, or spackling prior to painting. Test
adhesion, compatibility etc. There might be additional coats of
DUBRON Wall & Ceiling paint No. 406 necessary if the surface is
high-contrast, very smooth, strong or differently absorbing.
Application with an airless spraying device is particularly
advantageous when the surface is very smooth or high-contrast.If
the coats applied exceed to amount of coverage recommended the
wipe-ability is reduced and the dried paint will tend to appear
chalky. Remove fresh paint splashes with SVALOS Dilutant No. 292.
DUBRON Wall & Ceiling Paint No. 406 contains drying oils. High
humidity over an extended time period and delayed drying and may
cause odor. Please, be sure to provide adequate
ventilation.
View pdf version (34.7K)
These directions are the
result of long years of research and practical testing. They are
backed by our most current expert information. New findings may
invalidate this information. This data sheet is meant to serve as
information and instruction. No legal liability should be
interpreted from it. /n case of doubt, please contact the retailer,
wholesaler, or manufacturer. | 