DESCRIPTION: Ready to use silicate primer.
Used to thin BIO SILICATE PAINT and for priming Highly alkaline and
PREPARTION: According to Australia Standard 2311 –
The painting of buildings. The surface must be sound, free from
dirt and grease, clean and dry. Dispersion, latex, acrylic and oil
paint and any oil from concrete formwork must be completely
removed. (For example when using a paint stripper and all traces of
the coating and stripper must be removed by hosing or steam
cleaning.) Moisten new and very dry surfaces with water. To Repair
hairline cracks, use putty made from BIO Silicate Primer and quartz
APPLICATION: It is suitable for all interior and
exterior mineral surfaces like cement, stucco, sandstone, concrete,
brick and fibre cement but not gypsum lime based plaster.
Don’t use under 6 C or during greater heat above 30 C and in direct
sunlight. Freshly coated work should be protected from rain
- Density approx. 1.4kgs per 1 Litre
- Flammability: Not flammable
- PH-Value 11.4
- Temperature: Do not use under 6 C or above 30 C and in direct
sunlight weather conditions
- Compatibility: its mix ability with other silicate paint
products has not been tested.
INGREDIENTS: Potassium silicate with minute amounts
of an organic regulator according to German Standard DIN 18
CLEANING: Use water immediately
COVERAGE: 0.1 Kg per one sqm.
PRECAUTION: Alkaline! May irritate skin and
eyes. It is recommended that suitable protective measures are
taken. Eye goggles and necessary during handling, dilution
and application. Splashes on the skin or eyes should be
washed immediately with plenty of water. Remove splotches on
glass, clinker, bricks, stone, aluminium or lacquer immediately
with plenty water and otherwise there will be stains. KEEP AWAY
STORAGE: Keep cool and frost free.
Stores for approx 12 months.
The preceding information is given as a general guide only. Some
variations may occur or be advisable for particular conditions.
BIO SILICATE PRIMER is an environmental friendly product