|
DUBRON Natural Dispersion Paint No. 400
Application range: For interior surfaces such as plaster,
masonry, wood-derived materials (OSB), oatmeal wallpaper, gypsum
board, clay plaster and absorbent, sound, interior surfaces treated
with dispersion paint. Not suita¬ble for textile or vinyl wall
coverings.
VARIATION OF USES:
Technical qualities: Washable, very economical, low
tendency to drip or splash. Very good water vapour permeability.
Can be painted over with DUBRON White Plaster No. 465, and be
tinted at any ratio with URA Coloring Paste No. 410. German
certification DIN 55 987 for coverage strength. DIN 52 615
certified for water vapor permeability.
Ingredients: Water, chalk, titan dioxide, natural resins,
talcum, kaolin, proteins, orange oil,
Isoaliphates, methyl cellulose and silver chloride. Solvent
content less than 3 %. Colors White.
Dilution: For spray application only, dilute product 10 %
with water.
Coverage: 1 liter undiluted is sufficient for
approximately 9 m2 per coat. Could be considerably less
depending upon the condition and absorbency of the surface. Always
do a test coat!
Cleaning: Clean equipment immediately after use in warm,
soapy water using LATIS Natural Tool Cleaner No. 558.
Drying time: At 23°C and 50% relative humidity subsequent
coats can be applied after 12 hours. At low temperatures, high
relative humidity and reduced absorbency of the surface, drying
time can be significantly longer.
Specific gravity: Approximately 1.44 g/ml.
Safety advice: Contains limonene. Keep out of the reach
of children. If swallowed do not induce vomiting: seek medical
advice immediately and show this container or label.
Disposal: According to locally regulated laws.
Container sizes: 1 l; 5 l; 10 l; 30 l.
Storage: Cool and dry. Protect from frost and freezing.
Use contents of opened containers within 2-3 days. Please see label
for expiry date.
Packaging: Made of polyethylene (PE). This material is
ground water neutral and recyclable.
General Surface Requirements: The surface must be dry,
able to bear load, absorbent, neutral, clean and free of
separation agents, cracks, mold and fungi.
Preparation: Close holes and cracks with wall filler.
Structural cracks must be repaired with a crack-bridging repair
system. GRAVA No. must be diluted until there is no visible
film development. Please do a test application on the surface to be
treated.
Important Tips: Do not mix with products of other
manufacturers for coloring, varnishing, or spackling before
painting. If you work carefully on new oatmeal wallpaper,
you can coat the surface completely white with one single
coat. High-contrast or smooth surfaces, as well as surfaces with
high or varying absorbency may require two or three coats of
paint; in these cases, only the first coat may be diluted
with a max. of 5 - 10 % of water. Application with an airless
spraying device is particu¬larly advantageous on very smooth
or high-contrast surfaces.
Stir thoroughly before use. Remove splashes of paint immediately
with SVALOS Thinner No. 222. For coloring, mix URA Coloring Paste
No. 410 with twice the amount of DUBRON No.
400, and stir thoroughly. Then stir the mixture in the entire
amount of paint with a stirring device. The mixture must be stirred
continuously, and then applied sparingly with a brush or roller.
Assess the color with the help of a test coat which has to be
completely dry. An increasing concentration of URA No. 410 can
reduce the smear resistance.
Warning: Do not mix with pigment paste from other
manufacturers.
View pdf
version |
