DUBRON Natural Dispersion Paint No. 400
Application range: For interior surfaces such as plaster, masonry, wood-derived materials (OSB), oatmeal wallpaper, gypsum board, clay plaster and absorbent, sound, interior surfaces
treated with dispersion paint. Not suita¬ble for textile or vinyl wall coverings.
VARIATION OF USES:
Technical qualities: Washable, very economical, low tendency to drip or splash. Very good water vapour permeability. Can be painted over with DUBRON White Plaster No. 465, and be tinted at
any ratio with URA Coloring Paste No. 410. German certification DIN 55 987 for coverage strength. DIN 52 615 certified for water vapor permeability.
Ingredients: Water, chalk, titan dioxide, natural resins, talcum, kaolin, proteins, orange oil,
Isoaliphates, methyl cellulose and silver chloride. Solvent content less than 3 %. Colors White.
Dilution: For spray application only, dilute product 10 % with water.
Coverage: 1 liter undiluted is sufficient for approximately 9 m2 per coat. Could be considerably less depending upon the condition and absorbency of the surface. Always do a test
Cleaning: Clean equipment immediately after use in warm, soapy water using LATIS Natural Tool Cleaner No. 558.
Drying time: At 23°C and 50% relative humidity subsequent coats can be applied after 12 hours. At low temperatures, high relative humidity and reduced absorbency of the surface, drying time
can be significantly longer.
Specific gravity: Approximately 1.44 g/ml.
Safety advice: Contains limonene. Keep out of the reach of children. If swallowed do not induce vomiting: seek medical advice immediately and show this container or label.
Disposal: According to locally regulated laws.
Container sizes: 1 l; 5 l; 10 l; 30 l.
Storage: Cool and dry. Protect from frost and freezing. Use contents of opened containers within 2-3 days. Please see label for expiry date.
Packaging: Made of polyethylene (PE). This material is ground water neutral and recyclable.
General Surface Requirements: The surface must be dry, able to bear load, absorbent, neutral, clean and free of separation agents, cracks, mold and fungi.
Preparation: Close holes and cracks with wall filler. Structural cracks must be repaired with a crack-bridging repair system. GRAVA No. must be diluted until there is no visible film
development. Please do a test application on the surface to be treated.
Important Tips: Do not mix with products of other manufacturers for coloring, varnishing, or spackling before painting. If you work carefully on new oatmeal wallpaper, you can
coat the surface completely white with one single coat. High-contrast or smooth surfaces, as well as surfaces with high or varying absorbency may require two or three coats of paint; in
these cases, only the first coat may be diluted with a max. of 5 - 10 % of water. Application with an airless spraying device is particu¬larly advantageous on very smooth or
Stir thoroughly before use. Remove splashes of paint immediately with SVALOS Thinner No. 222. For coloring, mix URA Coloring Paste No. 410 with twice the amount of DUBRON No.
400, and stir thoroughly. Then stir the mixture in the entire amount of paint with a stirring device. The mixture must be stirred continuously, and then applied sparingly with a brush or roller.
Assess the color with the help of a test coat which has to be completely dry. An increasing concentration of URA No. 410 can reduce the smear resistance.
Warning: Do not mix with pigment paste from other manufacturers.
View pdf version